1. The first consideration in structural planning is the rigidity of the tool body and the processing properties of the material being processed.
Because of the irrational formation of the knife body, the user's differentiation process in the application process occurs from time to time. It is important that a qualified engineer with the appropriate depth of understanding of the tool is responsible for the structural planning of the tool.
In the actual use of woodworking tool manufacturers by woodworking tool manufacturers, the processed materials have developed from traditional wood (solid wood) to various composite materials, and the processing complexity is very prominent. For example: the appearance of the MDF is subjected to various chemical treatments, and the internal Variations in the content of ingredients, surface veneer (including aluminum, marble, copper, stainless steel, etc.). Before planning the tool structure, the engineer must first communicate well with the user of the tool, clarify all the basic conditions of the tool, and according to the status of the different processed materials. Then, based on the known information and the existing conditions of various resources such as the machine, raw materials, and personnel held by the factory, a reasonable structural planning and manufacturing process planning of the tool is performed.
2. After having a reasonable plan, the beginning enters the substantial tool processing stage. At this stage, it is roughly divided into seven steps: first, the turning and milling of the tool body. Second, the processing of forming a master. Third, the selection and preparation of alloys. Fourth, welding of forming milling cutter and alloy. Fifth, the forming process of forming milling cutters in woodworking tools. Sixth, the balance of the forming cutter. Finally, anti-rust treatment of the cutter body
3. The tool should be fully inspected before leaving the factory. At this time, the focus is on checking the welding quality. Some welding defects can only appear after sandblasting. To retain unqualified tools before leaving the factory, do not covet small profits and relax the quality requirements before leaving the factory.
4. After-sales service, after the tool arrives at the user, be sure to track the use of the tool, listen to as many bad feedback as possible about the tool, and guide and cooperate with the user to use the tool reasonably to achieve a good use.
